VACQPARING POD 

The VacQparing Pod brings vacuum work holding to the jobs where your tool goes all the way through your material. A dedicated shelf accepts a 1/2" waste board, so you can pare, chop dovetails, drill, and cut with your workpiece held rock-solid — and nothing sharp reaching your bench. At 12" x 4" overall, it packs a 9" x 4" vacuum area and a 3" x 4" waste board area into one compact pod.

• Built-In Waste Board Shelf - The 3" x 4" shelf takes a 1/2" waste board, giving chisels, drill bits, and blades something to bite into that isn't your workbench. Swap it out whenever it's chewed up.
  
• Rock-Solid Vacuum Hold - The 9" x 4" vacuum area locks your workpiece down flat and firm with nothing but vacuum. No clamps crowding the cut, no hold-downs to work around.
  
• Made for the Sharp Stuff - Paring, dovetails, through-drilling, chopping — the jobs that make you nervous about your bench top. Hold the work, protect the surface, keep going.
  
• Two Ways to Connect - Set Paring VacQpod directly over a VacQport (pt # VQPT01) and it pulls vacuum straight through. Or pull the plug and fit the included 1/4" push connector to run the pod off any vacuum source, on any surface.
  
• Sealed Top and Bottom - Ships with seal cord for both the top and bottom faces, so you get a clean seal against your bench and against your workpiece.