The VacQ Starter Kit is everything you need to start holding work with vacuum, right out of the box. You get the VacQube pump, two VacQports with two sets of seals each, and the double VacQswitch — plus all the airline and fittings needed to connect it together. Thread the ports through your bench, flip the switch, and your workpiece is locked down.

The VacQube Pump - A compact 12V negative-pressure pump delivering 75 kPa of holding power, remote-controlled by key fob and quiet enough to run beside you all day. The heart of the whole system.

Two VacQports - Thread them through your workbench or any work surface and hold work by atmospheric pressure alone — no clamps crowding your cut, every face and edge left open for routing, sanding, and planing.

Two Sets of Seals per Port - Each port ships with its full complement of VacQseals, so you're ready to hold work of different sizes and shapes from day one. No hunting for the right seal mid-setup.

The Double VacQswitch - Cut vacuum and vent pressure to release a workpiece instantly — then flip it back to grab the next one. Two switches on one mounting plate for controlling multiple holds at once.

All the Airline and Fittings - Every push-connect fitting and length of 1/4" airline you need to link the pump, switch, and ports together. Open the box and start holding work — nothing else to source.

Clamp-Free from Day One - This is the complete starting point for vacuum workholding on the bench. Add pods, ports, and accessories as you grow, but everything here works together right out of the box.