VACQPODS 

Take vacuum work holding anywhere you need it. Each hollow-bodied pod holds your workpiece flat and firm using nothing but vacuum — set a pod over a VacQport (pt # VQPT01) and drop your material on, or plug the pod into your vacuum source directly and put holding power on a surface that doesn't have a port at all. Either way, your work is locked down almost instantly and every face stays open.

• Two Ways to Connect - Set a pod directly over a VacQport (pt # VQPT01) and it pulls vacuum straight through — no plumbing, no setup. Or pull the plug and fit the included 1/4" push connector to run the pod off any vacuum source, on any surface.
• Holds Almost Instantly - Lay your workpiece on the pod and vacuum grabs it right away. No clamps, no waiting, no fiddling with hold-downs between pieces.
• Work Every Side - With the pod doing the holding, your material is completely open for routing, chiseling, sanding, planing, or finishing. Nothing in the way of your tool, nothing to work around.
• Sealed Top and Bottom - Each set ships with seal cord for both the top and bottom faces of the pods, so you get a clean seal against your bench and against your workpiece.
• Two Sizes, One Set - A 3" x 11" pod and a 1½" x 10½" pod, both a low 1" tall, cover everything from wide panels to narrow stock — use them individually or together for longer workpieces.